build a new boat.

we started build a new boat which is rob's designed. This boat is a sailing boat so it's totally different dory which we built the last project. I think everyone looking forward to it.

This picture is the theory what we are going to build a boat. This time we are not going to seperate each team, we are going to work just one team, so everyone has a charge each task like setting up, strip planking transom, foam, c/case etc. we also support each other doesn't meaning change work as a team.

1) setting up.

This is the frame all we need, those frame seprated each side so we needed to make some gussets which are connecting each frame side. The gusset length was 500mm but all heights were diffrent so we measured all heights of the frame. Before we connect each side of frame, we did a little bit sanding for making rough because we was going to glue on it. Actually we tried that way but failed. Because the frame had a gap, which means didn't fit right way so we tried to frame jig set up again

when we were the frame jig setting up again, we figured out Pythagoras theorem because if that measurment is right, it will be exeactly perpendicular. After that, make sure the frame has no gap and two people step on the each side of frame to doesn't move and then use a role to make some place between gusset and top side of frame, when we make sure all those things, then drilled and screw on it. when you finished the screw, you just a little bit unscrew and screw it again. This way can be make it much stronger rather than just screw.

                                                               < Pythagoras theorem >